-
Contact us
- Office Address: 253000, Chongde 5th Avenue, Gaotie New District, Dezhou, China
- Tel: +86-534-8127588
- Mob: +86-18865728871
- Email: sales@bright-tools.com
- Skype: sdjinjie101
-
DIN69871 SK Shrink Chuck Taper, Coolant
The same shrink fit tool holder blank can be installed with separate extension rods of different diameters/lengths.
-
DIN69893 HSK Shrink Chuck Taper, Coolant
The same shrink fit tool holder blank can be installed with separate extension rods of different diameters/lengths.
-
DIN69893 HSK-E Shrink Chuck Taper
The same shrink fit tool holder blank can be installed with separate extension rods of different diameters/lengths.
-
DIN69893 HSK-F Shrink Chuck Taper
The same shrink fit tool holder blank can be installed with separate extension rods of different diameters/lengths.
-
Precision Drill Chuck Holder
BT CPU Drill chuck ,worm and gear structure greatly increase the clamping power. integral structure increase the rigidity and accuracy. Runout reach 0.05mm. The claw use Nitriding process increase the wear resistance and longer tool life
-
MAS 403 Pull Back Collet Chuck
Pull Back Collet Chuck
Built-in collet design
More suitable for high speed machining
Reduced interference when machining without nuts
-
DIN 69871 SK ER Collet Chuck with UM Nut
ER Collet Chuck with UM Nut
SK-ER tool holder is a commonly used tool holder in machine tool processing. It is composed of a tool holder body and an ER collet. It is mainly used to clamp and fix straight-shank cutting tools such as drills and milling cutters machining.
1.Various specifications: ER11, ER16, ER20, ER25, ER32, ER40
2. Easy to operate
3, Wide applicability
-
DIN 69871 SK Power Milling Chuck
Power Milling Chuck
SK-Milling chuck is suitable for drilling and heavy cutting, High clamping force increases productivity and extends tool life
1.Triple seal to prevent iron filings and coolant pollution
2. Contains ball bearings to reduce frictional resistance and parts loss during locking
3. High beating accuracy, 3 times the diameter beating 5-8u
-
DIN 69871 SK Power Milling Chuck
Pull Back Collet Chuck
Built-in collet design
More suitable for high speed machining
Reduced interference when machining without nuts
-
DIN 69871 SK Power Milling Chuck
End Mill Holder Whistle Notch
End mill holders hold cutting tools with more rigidity than collets. Available in Weldon type for using tools with Weldon flats.
Easy to use for clamping tools and disassemble tools.
This clamping system assures the end mill cannot spin in the holder during a heavy cut as is possible in a collet.
Leave a message
